Assembly Instructions

Make sure you have enough floor space to assemble the facilitation board.

Remove all components from the bag.

Place the cardboard piece for the legs on the floor and unfold it.

Fold the smallest section of the perforated cardboard toward the centre. Also, fold both diagonals. Fold slowly and along the entire length.

Fasten all three cardboard layers together using the wooden pins: first insert the large pin, then insert the small pin into the hole in the large pin from both sides.

Repeat the same folding and fastening process on the opposite side.

Repeat the same process to build the second leg.

Lay the two main facilitation board panels flat and unfold them.

Position the two board panels so that the holes line up and the panels support each other in an open standing position (forming a <> shape).

Fasten the edge furthest from the holes using the metal binder clips.

Stand the connected facilitation board upright and insert the leg piece (the side with holes) between the two board panels.

Carefully line up the holes through all four cardboard layers and fasten them using the wooden pins.

Secure the layers. First insert the large pin, then insert the small pin into the hole of the larger pin.

Repeat the fastening process for the lower hole.

Repeat the same assembly process on the other side. Make sure all wooden pins are firmly in place.

Well done! Your facilitation board is ready to use. Now it’s time to turn ideas into action.